Check for any system warnings (for example in Device Manager in Windows) about the Universal Serial Bus Controllers.Limit USB bandwidth whilst recording by using other USB devices sparingly, for example simply disconnecting from the Internet may help if you use a USB modem for Internet access.Check the USB cable for tightness at both ends and try using a different cable instead.Check the Project Rate bottom left of the Audacity screen is set to either 44,100 or 48,000 Hz - setting a very high rate might overload the USB bandwidth and cause transmission problems.Generally they are not caused by Audacity, but by poor quality equipment and cables, or lack of sufficient USB bandwidth. Reports of recordings from USB turntables freezing or having dropouts are not that uncommon. When the computer has finished rebooting, open Audacity and see if the USB device is now in the Recording Device list. Wait a couple of minutes then completely shut down the computer and restart.Plug it back into the USB port, and switch it on.Switch off and unplug the turntable at the USB connection and at the mains.Unplug all other USB devices (on Windows, use the "Safely Remove Hardware" icon in the System Tray). If that does not help follow, this sequence and reboot Try using another USB cable - sometimes a faulty cable can cause this problem. Ensure you are plugging into a spare USB port, not a USB hub. Make sure the turntable is plugged into the mains and switched on, and its USB cable is connected to the computer. If you connected the turntable while Audacity was already running, try Transport > Rescan Audio Devices or exit Audacity and relaunch it. If the USB audio codec is not recognized in the Audacity Device Toolbar, you cannot record from it. Turntable not recognized by operating system
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |